BTDSys Stutter

Installation

Put BTDSys Stutter.dll in your Gear\Generators folder.

Notes

• There is an attribute to set whether the End/Length parameter sets the absolute end point, or the loop length (relative to the start point).
• If the end point is before the start point (or length is negative), the loop plays in the opposite direction to "normal".
• Inertia A applies to Start and End/Length, Inertia B applies to Loop Time, Rate and Volume.
• Only one of Loop Time or Rate is used at once (the one chosen by the Rate Par parameter). The other is just ignored.

Contact

Docs and code ©Ed Powley (BTDSys)